Futaba 6EXAP 6-Channel PCM 40MHz/ R146IP 富他巴 [6EXAP_c4]

價格:

HKD$987.32

牌子:

Futaba

型號:

6EXAP_c4

售罄

請輸入姓名和電子郵件地址。當貨品重新上架我們將笫一時間通知閣下.

你或可於 R/C Models - System - Transmitter - Flight Transmitters
類別中嘗試尋找類似的產品

填寫評論

產品說明

FEATURES:

Aileron, Elevator and Rudder dual rate switch - Use this switch to flip between two aileron, elevator and rudder control throw settings. The throws can be set up however you prefer, but generally, when the switch is up the throws are greater (high rate) and when the switch is down the throws are less (low rate). This switch also flips between exponential rates (if used).
Flap control dial/Channel 6 - This dial operates the servo connected to channel 6 in the receiver if your model has flaps this is the control used to operate them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to shift the neutral or center position of each servo as labeled in the diagram.
Charging jack - Port for charging the transmitter batteries with the included battery charger.
On-off switch
DATA INPUT lever - Used to change the values of the various functions displayed on the LCD screen.
Liquid-crystal display screen (LCD) - Displays programming modes and values entered.
MODE key - Used to scroll through and display the ten or eleven(PCM) different functions.
SELECT key - Used to display the values for the current function.
Throttle-cut button - To use the throttle-cut function, lower the throttle stick all the way, then Push the throttle-cut button to fully close the carburetor and shut of the engine.
Throttle/rudder control stick - Operates the servos connected to channel 3 (throttle) and channel 4 (rudder) in the receiver.
Trainer switch - Operates the trainer functions. To operate as a trainer switch the transmitter must be connected to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - Switch operates the servo connected to channel 5 in the receiver if your model has retractable landing gear this is the control used to extend and retract the gear.
Antenna - Radiates signals to the receiver. Never fly a model without fully extending the antenna or you may create interference to other modelers and decrease operational signal range of the transmitter. The antenna may be removed and replaced with another in case it is inadvertently broken.

INCLUDES:
Futaba 6-Channel 6EXAP transmitter
Futaba R146IP Receiver
Switch Harness
Manual

SPECS:
Transmitter
T6EXAP Transmitter with programmable mixing and 6-model memory.
Transmitting on 40 / 72 MHz band.
Operating system: 2-stick, 6-channel system
Modulation: FM(PPM) and PCM
Power supply: 9.6V NT8S600B Ni-Cd battery or 12V alkaline battery
Current drain: 250mA

熱門品牌

Futaba 6EXAP 6-Channel PCM 40MHz/ R146IP 富他巴 [6EXAP_c4]